1993 cherokee fluid jeep manual transmission type


















A Wheel-lift or Sling-type device can be used provided all the wheels are lifted off the ground using tow dollies. NOTE: When a frame-contact type hoist is used, verify that the lifting pads are positioned properly Fig.

If using the wheel-lift towing method, install tow dollies under rear wheels. Some Jeep vehicles are equipped with front emergency tow hooks. Support the vehicle in the raised position with jack stands at the front and rear ends of the frame rails. European Grade 10W oils are also acceptable. Model The following are engine related Maintenance items which are unique to Diesel engine-equipped vehicles.

Refer to the ZJ Service Manual for gasoline engine and non-engine related Maintenance Schedules The service intervals are based on odometer readings in kilometers. There are two maintenance schedules that show proper service intervals. Clean as necessary. Refer to Group 9, Engines for head gasket identification.

Change engine oil filter. Replace air filter element. Check drive belt tension. Check glow plug operation.

Replace drive belt. Check engine smoke. Replace engine coolant. Get notified when we add a new Jeep Cherokee Manual Notify me.

Get notified when we add a new JeepCherokee Manual. Notify me. We cover 60 Jeep vehicles, were you looking for one of these? Thanks for visiting my little site! Can you help keep us online? Or add your coupon if you have it?

Thank you for visiting OnlyManuals. Log In Username. Login Forgot Your Password? Forgot Your Username? New Customer? Create an Account. My Account Orders list Wishlist Checkout. Plug all openings to prevent fluid loss and contamination. Support engine with safety stand. Disconnect or remove following: transmission and transfer case shift linkage; necessary exhaust components; speedometer cable; transmission wiring harnesses; transfer case vacuum and wiring harnesses.

Disconnect drive shafts at transfer case and wire to frame rails. DO NOT allow drive shafts to hang free as damage to universal joints may result.

Remove rear crossmember. Disconnect necessary vacuum and fluid hoses and transmission throttle cable at engine. Remove starter. Remove converter-to-drive plate and converter housing-to-engine bolts. NOTE: Remove transfer case from transmission if transmission is to be overhauled. Installation 1 To install, reverse removal procedure.

On 4WD models, connect transfer case shift linkage and vacuum hoses. Install new "O" ring seal on upper half of transmission fill tube. Connect upper and lower tube halves. Raise vehicle. Remove converter inspection cover and fill tube. Plug fill tube hole to prevent fluid loss and contamination. Drain transfer case lubricant.



0コメント

  • 1000 / 1000